WEEK 6(FYP2)- BUILD THE HARDWARE PROTOTYPE FOR THIS PROJECT

Objective:

1) To build the hardware prototype for this project.
2) To measure the correct dimension size for the hardware prototype.         
     

Analysis/Discussion:

During week 6 basically measure the dimension of the all circuit to build the hardware prototype. Then to cut the prospect according to the size of the measured to build the hardware prototype.The dimension that use to build the hardware prototype for this project about the 20 cm wide x 24 cm length x 11 cm height.  After that, glue all prospect that cut by using the glue gun.

Figure 1 : process cut the prospect

Conclusion: 

Finally, the hardware prototype for this project is already done.